Hydrotherapy tub, cleaning and disinfection Educational Bulletin

Drain tank completely. Close drain. 2. Use microfiber tool and pad pre-soaked with ... with fresh water. Use the hose from the tub to rinse the recirculation system in the same manner chemical was run through. 8. Close the drain and fill the tub with fresh, hot water to a point that the chair may be submersed. 9. Lower the chair ...
351KB Sizes 0 Downloads 83 Views
The Experts in Sanitation Solutions Subsidiary of Sani Marc Group

woodwyant.com 1 800 361-7691

August 2017

Educational Bulletin Hydrotherapy tub, cleaning and disinfection RECOMMENDED PRODUCT

BETWEEN RESIDENT USE

For Hydrotherapy tub cleaning and disinfecting is the 0.5% hydrogen peroxide based Saber disinfectant.

1. Drain tank completely. Close drain.

Purging and disinfecting requires 1-16 dilution (64 ml/L) Sanitizing requires 1-128 dilution (8 ml/L) Saber has both the general bactericide capability and general virucide claims and is effective at 1-16 against non- enveloped virus.

2. Use microfiber tool and pad pre-soaked with Saber to scrub the interior of the tub 3. Wash all other surfaces including lift chair using microfiber hand cloth pre-soaked with Saber and allow to air dry. 4. After cleaning all surfaces, use the hydro foamer filled with Saber and apply disinfectant to the interior of the tub and lift chair, allow to stand for 5 minutes 5. Drain and rinse the interior of the tub with water prior to the next resident usage

DURING AN OUTBREAK OR AT THE END OF THE DAY • Ensure the required concentration is achieved in the tub. • Start the jets on and circulate the solution. • Shut down the jets and allow at least 5 minutes for the solution to sit in the lines and nozzles. • Clean and disinfect the tub surfaces. • Empty the tub and refill with just water then turn the jets back on again to rinse the lines and tub. Follow the steps on the following pages depending on the system you have.

The Experts in Sanitation Solutions

woodwyant.com 1 800 361-7691

Subsidiary of Sani Marc Group

August 2017

Educational Bulletin STEPS FOR A TUB WITHOUT A CHEMICAL DISPENSER

STEPS FOR A TUB WITH A CHEMICAL DISPENSER

1.

1.

2. 3.

4.

5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16.

Ensure that you have all the tools and supplies you will need. Drain tank completely. Close Drain. Ensure to measure how much water is in the tub to be sure that we have added enough Saber. Figures to be added based on 260 liter tub needing 960 ml per 15 liters of water. For customers adding manually we will need the figures for both the Saber and de-foam. In order to reduce the amount of foam generated add 5% of the volume of the Saber in the tub to knock back foam generation. Fill the tub with cool water and the required 1-16 Saber. Start the jets and circulate for 5 minutes. Turn the jets off and allow the Saber to sit in the lines for 5 minutes. Clean the surfaces inside of the tub. Start the jets again and circulate for a further 5 minutes. Empty tub. Use microfiber tool and pad pre-soaked with a solution of Saber to scrub the interior of the tub. Wash all other surfaces including lift chair using microfiber hand cloth pre-soaked with Saber and allow to air dry. After cleaning all surfaces, use the hydro foamer filled with a solution of Saber and apply disinfectant to the interior of the tub and lift chair, allow to stand for 5 minutes. Once more refill the tub with cool water to just above the nozzles. Start the jets and circulate for 30 seconds to rinse the lines and the tub Shut down the jets, drain tub and allow to air dry.

Ensure that you have all the tools and supplies you will need. 2. Drain tank completely. Close Drain. 3. Place the hose from the chemical dispenser in tub and start dispenser. As illustrated, place the hose in the upper jet and allow the Saber to flow through. Repeat this for second jet. 4. Use hose to wet all the surfaces of the tank and turn dispenser off. 5. Use microfiber tool and pad pre-soaked with a solution of Saber to scrub the interior of the tub. 6. Lower the chair into the tub and use same cloth to thoroughly wipe all services of the chair. Allow tub and chair to sit for 5 minutes to insure proper disinfection. 7. Drain the tub. Rinse the