Remote Controlled Switch. Remote controlled switch - 3rdbrakeflasher

3 downloads 313 Views 143KB Size Report
from 6V to 20V. Remote control distance is about 1000 feet in the open field. Receiver operates in three programmable mo
Remote Controlled Switch. Remote controlled switch is applicable to wide range of applications from garage door opener to light control. It can be connected to application with DC voltage from 6V to 20V. Remote control distance is about 1000 feet in the open field. Receiver operates in three programmable modes: non-latching, latching and timed modes. Configuration is done via a single button. Each receiver can be paired with up to 10 different remotes. Each remote has four separate buttons and can control up to four separate receivers. 10 amp output capacity.

*** For up to date installation instructions and videos visit www.bit.ly/rcnt3

Please read the entire manual before connecting and configuring remote switch.

Connect remote controlled switch according to the diagram. Red and Orange - Power Black - Ground White/Green - Configuration button Yellow - Output Brown - Antenna Page 1

To pair remote with receiver: 1. Push and hold configuration button. 2. Supply power to the receiver. 3. Power to the load will be supplied for a brief moment. Wait for about 5 seconds until the power briefly supplied to the load for the second time and then release the button. Receiver is ready to be paired with remote. 4. Push selected button on the remote to pair with the receiver. Power to the load will be supplied for 1 sec to confirm successful pairing. 5. Turn the power off.

To configure receiver for non-latching mode: 1. 2. 3. 4.

Push and hold configuration button. Supply power to the receiver. Power to the load will be supplied for a brief moment. Release the button. Turn the receive power off.

To configure receiver for latching mode: 1. 2. 3. 4.

Push and hold configuration button. Supply power to the receiver. Power to the load will be supplied for a brief moment. Release the button. Push and release button one time and disconnect power.

To configure receiver for timed mode: 1. 2. 3. 4.

Push and hold configuration button. Supply power to the receiver. Power to the load will be supplied for a brief moment. Release the button. Push and hold the configuration for required time duration and then release (for example: push the button for 10 sec if you need timed signal to be 10 sec). 5. Push and release the button one more time and disconnect power.

Now you can operate the remote. Push paired button on the remote to turn the receiver output on and off. Alternatively you can push configuration button to turn on and off the receiver output.

Page 2