unece

Sep 24, 2002 - "relative visual attenuation quotient" means the relative visual quotient (Q) and is defined in annex 13. 2.14. "basic plane of the human head" means a plane at the level of ..... Sliding bar and double-D ring fastening devices shall be fitted with a pulling flap to be used for releasing the retention system.
1MB Sizes 6 Downloads 238 Views
E/ECE/324 E/ECE/TRANS/505

Rev.1/Add.21/Rev.4

24 September 2002

AGREEMENT CONCERNING THE ADOPTION OF UNIFORM TECHNICAL PRESCRIPTIONS FOR WHEELED VEHICLES, EQUIPMENT AND PARTS WHICH CAN BE FITTED AND/OR BE USED ON WHEELED VEHICLES AND THE CONDITIONS FOR RECIPROCAL RECOGNITION OF APPROVALS GRANTED ON THE BASIS OF THESE PRESCRIPTIONS ∗/ (Revision 2, including the amendments which entered into force on 16 October 1995) __________

Addendum 21: Regulation No. 22 Revision 4 Incorporating all valid text up to: 05 series of amendments - Date of entry into force: 30 June 2000 Corrigendum 1 to the 05 series of amendments, subject of Depositary Notification C.N.427.2000.TREATIES-1 dated 27 June 2000 Corrigendum 2 to the 05 series of amendments, subject of Depositary Notification C.N.133.2001.TREATIES-1 dated 13 March 2001 Corrigendum 3 to the 05 series of amendments, subject of Depositary Notification C.N.815.2001.TREATIES-2 dated 23 August 2001 Supplement 1 to the 05 series of amendments - Date of entry into force: 20 February 2002 **/

UNIFORM PROVISIONS CONCERNING THE APPROVAL OF PROTECTIVE HELMETS AND THEIR VISORS FOR DRIVERS AND PASSENGERS OF MOTOR CYCLES AND MOPEDS ___________

UNITED NATIONS

∗/

Former title of the Agreement:

Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958. **/

For New Zealand, the entry into force is 20 April 2002.

E/ECE/324 Rev.1/Add.21/Rev.4 E/ECE/TRANS/505 Regulation No. 22 page 3

Regulation No. 22 UNIFORM PROVISIONS CONCERNING THE APPROVAL OF PROTECTIVE HELMETS AND OF THEIR VISORS FOR DRIVERS AND PASSENGERS OF MOTOR CYCLES AND MOPEDS

CONTENTS REGULATION

Page

1.

Scope ................................................................

5

2.

Definitions ..........................................................

5

3.

Application for approval .............................................

7

4.

Markings .............................................................

9

5.

Approval .............................................................

9

6.

General specifications ............................................... 12

7.

Tests ................................................................ 21

8.

Test reports ......................................................... 43

9.

Production qualification ............................................. 43

10.

Conformity of production and routine tests ........................... 45

11.

Modification and extension of approval of a helmet or a visor type .......................................... 53

12.

Penalties for non-conformity of production ........................... 54

13.

Production definitely discontinued ................................... 54

14.

Information for wearers .............................................. 54

15.

Transitional provisions .............................................. 56

16.

Names and addresses of technical services responsible for conducting approval tests, and of administrative departments .................................... 57

E/ECE/324 Rev.1/Add.21/Rev.4 E/ECE/TRANS/505 Regulation No. 22 page 4

CONTENTS (continued) ANNEXES Annex 1

-

Communication concerning approval or extension or refusal or withdrawal of approval or production definitely discontinued of a protective helmet and visor type pursuant to Regulation No.