Wall Mount Installation

1 downloads 132 Views 76KB Size Report
Installing the Wall Mount: 1. Decide where the phone or BB24 will be located. We recommend mounting near an Ethernet jac
Wall Mount Installation for the ShoreTel 110 and 115 IP Phones and BB24 Button Box Tools Required:

Also Supplied:

- pencil - drill - screwdriver - studfinder (optional)

- (4) wood screws - (4) “molly” hollow wall anchors - Special Ethernet cable with sharp bend at the RJ-45 port

Installing the Wall Mount: 1. Decide where the phone or BB24 will be located. We recommend mounting near an Ethernet jack. 2. Use a studfinder to locate the wall stud (skip this step if your are using “molly” hollow wall anchors). 3. Place the wall mount at the desired location and use the wall mount as a template. Then, use a pencil to mark where the screws will go. 4. Use a drill to bore a small hole at each pencil mark. 5. Insert screws (or “molly” anchors) into the drilled holes and drive the screws into the wall until only 1/4 inch remains exposed. 6. Position the wall mount against the wall with the screws protruding. 7. Slide the wall mount downward until it settles into place. 8. Tighten the screws to create a snug fit. &IRST INSERTTWO UPPERTABSHERE

Mounting the Phone or Button Box: 1. Unplug and remove the handset and stationary base from the IP phone. (Skip this step if you are installing the BB24.) 2. Plug the Ethernet cable (shipped with the wall mount) into the RJ-45 port of the phone or BB24 before mounting the device. (It may be too difficult to attach the cable after the device has been mounted.) 3. Insert the wall mount’s upper two tabs into the slots on the device’s rear panel. Then, roll the base of the phone or BB24 toward the lower tabs and snap in place. (Apply upward pressure on the lower tabs, if necessary.) 4. Reconnect any loose cables and wait for the phone or BB24 to reboot before attempting to place a call.

RD WA AC K E 4HENROLLBINPLAC ANDSNAP

Exposing the Wall Mount Handset Retainer on the IP 110 or 115: 1. To prevent the phone handset from falling to the floor, use your thumb or fingernail to pry the wall mount handset retainer out of its housing (as indicated by the arrow in the left-most section of the illustration below). 2. The retainer is composed of two separate pieces that are held together by a screw. Take a firm hold on the lower piece and then rotate the upper piece 180 degrees. 3. Reinsert the retainer back into the groove such that the tab is now exposed.







3HORE4EL

Note: The handset retainer procedure does not apply to the BB24 because it does not have a handset.





ShoreTel, Inc., 960 Stewart Drive Sunnyvale, California 94085 USA Phone: +1.408.331.3300 +1.800.425.9385 Fax: +1.408.331.3333 800-1042-02 Copyright © 1998-2007 by ShoreTel, Inc., Sunnyvale, Californio, U.S.A. All rights reserved.

www.shoretel.com